DipTrace Forum

I am working on a project that requires fine control over the paste mask. Is it feasible to modify the paste mask's length and breadth independently? If yes, could you please provide comprehensive instructions or direct me to appropriate resources?

I'm especially interested in the ability to tailor these parameters to ensure proper solder paste application and avoid potential flaws.

No but there is a workaround, see viewtopic.php?t=15772 for more info.

Would be a nice change to Diptrace.

Flux wrote: 23 Aug 2024, 16:31 No but there is a workaround, see viewtopic.php?t=15772 for more info.
Quick Draw
Would be a nice change to Diptrace.

yes i think that is a really good solution