Placing components on back of pcb.

[mlgch1]

How do I place an smd component on the back of a pcb with the correct orientation.
I can place a component on the front then "change sides" but this orients it as it appears from the front.
If I try to place a component on the back it actually goes on the front.

[amshh]

You have always a kind of glas view through the pcb.
No way if you are on Top layer (Keypad-T) or Bottom layer (Keypad-B)
If you want to see the Bottom layer as a PCB you turned in your hand,
execute the Mirro funtion (View >> Mirror)

[mlgch1]

The problem is not what it looks like but how to place a component with the correct orientation.

[amshh]

Sorry, cannot see your issue.
Go on the PCB's Bottom Layer and activate Mirror View.
Then you have the correct orientation and can place your
components just like on a physical PCB's bottom side.
What are you missing moreover?