Strange panel gerber output
Posted: 07 Nov 2024, 03:42
I panelized a PCB. The panel has rails and mouse bites. I added panel fiducials and stencil alignment holes to the rails. When I look at the gerber file, there are rail fiducials and alignment holes beyond the panel margins.
Why is this happening?
Also is it possible to have a negative offset for the mouse bites, to draw them away from the PCB?
Why is this happening?
Also is it possible to have a negative offset for the mouse bites, to draw them away from the PCB?
- Panel gerber.png (90.44 KiB) Viewed 818 times